Installing a Brick Driveway in 15 Steps

Brick Driveway Installation

When it comes to brick driveways, they have the power to easily improve the look of the properties where they’re installed. Not only are they easily maintained, but they also blend in very well with the landscape. One of the main reasons of using bricks is because they can be installed without the help of professionals, so let’s take a closer look below at how you can easily install them on your own.

You can watch this entire process on a video or keep reading below it.

Step One

The first step you should take involves laying out the driveway in your desired shape. Using marking spray paint and wooden stakes for this step. When laying out the shape, you may want to use a string line that’s going to be tied between stakes, since it’ll keep you on grade. Also, make sure that when completed, the driveway can be easily drained.

Step Two

The area of the driveway needs to be excavated to a depth of minimum twelve to fourteen inches and next you’ll have to compact the raw sub-grade. There’s going to be a lot of material that needs to be disposed of because of the excavation, so make sure to hire an excavator to dispose of it properly. By hiring a professional excavator contractor, he’ll provide you with the personnel, haul truck, location for hauling off the waste and all other equipment required to get the job done properly.

Step Three

At this point you’ll need to get the stone base which is to be used as support for the drain and brick (pea gravel or stone screenings will do just fine).

Step Four

The stones should be dumped in manageable piles on the sub grade. Use a garden rake, a wheelbarrow and shovels to spread the rock properly.

Step Five

Install the stone in three lifts using a plate vibrator.

Step Six

The last lift of stone should be held to a grade which allows for 2” of sand and the 3” brick paver.

Step Seven

To prevent weeds from coming up between the pavers, you’ll need to use landscape cloth for covering the stone.

Step Eight

In order to bed the paver block in, you should consider placing 2” of sand over the cloth. Abiding by the manufacturer’s instructions, you should then proceed with setting a plastic brick edge retainer.

Brick pavers installation step by step

Step Ten

To keep even spacing, you should use brick spacers and being at the middle of your driveway’s end and then work out towards the edges. By doing so, you’ll ensure that the bricks on each edge or side are going to be of the same size and provide a uniform look.

Step Eleven

Use a 3′ length of two by four inch wood for laying across the bricks every 2-3 feet. To ensure the bricks will be evenly settled into the bed of sand, you should tap the wood using a rubber mallet.

Step Twelve

You should consider starting at the 2nd row by making sure you center the brick over the joint of the two bricks in the center. By doing so, you’ll get a beautiful herringbone pattern.

Step Thirteen

Follow the previous three steps until you complete the driveway.

Step Fourteen

Fill the joints between the brick by using masonry sand. You should spread it over the bricks and carefully sweep it into the joints.

Step Fifteen

Lastly, to settle the sand into the joints, you should spray water (using a hose). By doing so, you’ll also be able to clean off the bricks.